Pre-Maintenance Procedures; Releasing The Mower-Deck Curtain; Removing The Sheet-Metal Guard - Toro Z Master 4000 Series Operator's Manual

Maintenance Service
Interval
Monthly
Yearly
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Shut off the engine and remove the key from the switch before you perform any maintenance.
Pre-Maintenance
Procedures
Releasing the Mower-Deck
Curtain
Remove the cotter pin to release the mower-deck
curtain and get access to the top of the mower deck.
After performing maintenance, install the curtain using
the previously removed cotter pin.
Removing the Sheet-Metal
Guard
Loosen the 2 front bolts and remove the sheet-metal
guard to access the mower belts and spindles
(Figure 38). After performing maintenance, install the
sheet-metal guard and tighten the bolts.
Maintenance Procedure
• Check the battery charge.
• Repack the caster-wheel bearings (more often in dirty or dusty conditions).
• Greasing the caster-wheel hubs.
• Paint chipped surfaces.
• Complete all the procedures in the Storage chapter.
1. Sheet-metal guard
35
Figure 38
2. Bolt
g027946