Troubleshooting - Asko DBI652 S Series Operating Instructions Manual

Troubleshooting

Type of fault on the display
F10 Overfilling water 1
F11 Water outlet fault
F12 Water inlet fault
F40 Inlet valve leakage
F52 Water level fault
F54 Overfilling water 2
F56 Circ. pump fault
Press any button to clear the error message.
Problem
The buttons do not react when pressed.
Cannot close door.
The dishwasher does not start.
16
Action
Clear the drain pump. See the section Care and maintenance instructions. If the problem persists,
call the Customer Care Center.
See "Water remains in the dishwasher above the filters" in the table "Problem" below. If the problem
persists, call the Customer Care Center.
Check that the water supply valve is on. If the problem persists, call the Customer Care Center.
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and call the Customer Care Center.
Call the Customer Care Center.
Turn off the water supply valve and call the Customer Care Center.
Call the Customer Care Center.
Possible causes
You have pressed the buttons too soon after
opening the door.
Child lock (button lock) activated.
The door is closed.
The buttons are dirty.
The baskets are not correctly positioned.
The Start/Stop start button has been pressed for
too short a time.
The door is not closed properly or was not closed
immediately after pressing the Start/Stop button.
You have opened the dishwasher to add more
dishes while a program is in progress.
A fuse/circuit breaker has been tripped.
The plug is not plugged into the power outlet.
The water supply valve is turned off.
Overflow/leaks.
A whirring sound (the drain pump) is heard from
the dishwasher and does not stop when the main
power switch is turned off.
Check that the Delayed Start option has not been
selected.
Action
Wait a moment then try again.
See the chapter Settings.
Open the door. The buttons only react to use
when the door is open.
Clean with a dry or slightly damp cloth.
Check that the baskets are correctly positioned
horizontally.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Press and hold Start/Stop until the display shows
"Program started, close door in 4 sec".
Close the door within four seconds, otherwise
the dishwasher will not start.
If you want the dishwashing program to continue,
press Start/Stop and close the door within five
seconds.
Check.
Check.
Check.
Check.
Turn off the water supply valve. Pull out the plug
and call the Customer Care Center.
Press and hold Start/Stop for three seconds if
you want to cancel the Delayed Start option.