Playing Back The Added Sound - Canon 10 Instruction Manual

7. Press the STOP 3 button on the wireless controller
to stop dubbing.
Audio device: Stop playback.
Set the zero set memory at the end of the scene you wish to dub audio. The
camcorder will automatically stop audio dubbing at that point.

Playing Back the Added Sound

You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust
the balance of both sounds.
MENU button
Selector dial
CAMERA
AUDIO SET UP
( 43)
1. Open the menu and select [AUDIO SET UP]. Select [12bit AUDIO OUT],
select a setting and close the menu.
• STEREO1: Plays back the original sound.
• STEREO2: Plays back the added sound.
• MIX/FIXED: Plays back stereo 1 and stereo 2 in the same level.
• MIX/VARI.: Plays back stereo 1 and stereo 2. The mix balance can be adjusted.
2. If you have selected [MIX/VARI.], adjust the mix level: Open the menu
and select [AUDIO SET UP]. Select [MIX BALANCE], adjust the balance
with the selector dial and close the menu.
Turn the selector dial down to increase the volume of Stereo 1 and up to increase the
volume of Stereo 2.
❍ The camcorder resets to [STEREO1] when you turn the camcorder off. However,
the mix balance is memorized by the camcorder.
❍ You can also press the 12bit AUDIO OUT button on the wireless controller to
select the audio output. However, the mix balance can only be adjusted in the
menu.
PLAY (VCR)
12bit AUDIO•••STEREO1
12bit AUDIO
OUT button
CARD CAMERA
ZERO SET
REW PLAY FF
MEMORY
12bit
STOP
AUDIO OUT
PAUSE SLOW 2
AUDIO DUB.
AV INSERT AV DV REMOTE SET
CARD CAMERA
E
99