Electrolux ERN1300FEW User Manual page 25

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
8.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
Possible cause
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
25