Table of Contents
Advertisement
Note
● When the foot controller is plugged in, the start/
stop button cannot be used to start sewing (only for
models equipped with the start/stop button).
Sewing speed controller
(for models equipped with
the start/stop button)
a
Slide the sewing speed controller to select the
desired sewing speed.
a Sewing speed controller
• The speed set using the sewing speed
controller is the foot controller's maximum
sewing speed.
Changing the needle stop position
Normally, the sewing machine is set to leave the needle in the
fabric when sewing is stopped. Instead, the machine can be set
to leave the needle raised when sewing is stopped.
a
Turn off the sewing machine.
b
Hold down the "–" side of
sewing machine.
c
After turning on the sewing machine, release the
"–" side of
(
).
a
The needle stop position changes to the raised
position.
Memo
• Perform the same operation to change the
needle stop position to the lowered position.
(
) and turn on the
a
Changing the initial needle
position
Normally, the straight stitch (left needle position) is
automatically selected when the sewing machine is
turned on. The initial needle position can be changed
to the straight stitch (center needle position).
Turn off the sewing machine.
a
b
Hold down the "+" side of
the sewing machine.
After turning on the sewing machine, release the
c
"+" side of
(
).
b
The initial needle position changes to the
center needle position.
Memo
● The specified initial needle position is maintained
even after the machine is turned off.
● Perform the same operation to change the initial
needle position to the left needle position.
Cancelling the operation beep
(for models equipped with the
operation beep)
When the sewing machine is purchased, it is set to
beep each time a key is pressed. This setting can be
changed so that the machine does not beep.
Turn off the sewing machine.
a
b
Hold down the "–" side of
the sewing machine.
After turning on the sewing machine, release the
c
"-" side of
(
c
The machine is now set so that it will not
beep.
Memo
● Perform the same operation to change the setting
so that machine beeps.
(
) and turn on
b
(
) and turn on
c
).
1
9
Hide quick links:
Advertisement
Table of Contents
