Download Print this page

Powerware TVSS ZoneMaster PLUS Installation Instructions & User Manual

Ac panel transient voltage surge suppressors

Advertisement

Quick Links

Installation
Instructions
& User Manual
P
owerware TVSS
Z
M
PLUS
®
ONE
ASTER
AC Panel Transient Voltage Surge Suppressors

Advertisement

loading

Summary of Contents for Powerware TVSS ZoneMaster PLUS

  • Page 1 Installation Instructions & User Manual owerware TVSS PLUS ® ASTER AC Panel Transient Voltage Surge Suppressors...
  • Page 2 NTRODUCTION This document explains how to install the Powerware TVSS ZoneMaster PLUS AC Panel Surge ® Protection Devices. NSTALLATION NSTRUCTIONS Warning: Terminals marked L1, L2, L3, N, GND (where relevant) must be connected respectively to phase(s) neutral and ground. Failure to comply may result in danger or damage. See corresponding diagrams for proper connections.
  • Page 3 TATUS NDICATORS The Powerware TVSS ZoneMaster PLUS units have comprehensive, continuous visual ® status monitoring present on each module. Reduced Full Status (Standby) Protection Power To Indicated Present Protection Protector Protection Both Both Both Indication Window Windows Windows Windows Windows...
  • Page 4 ONNECTING EADS Connect the suppressor as shown in the installation diagram. Refer to page 5 for recommended cable dressing. The recommended installation is to connect the terminals within the suppressor to the load side of 60A breakers or fuses within the panel. See specific connection diagrams for more details and markings on unit if provided.
  • Page 5 RECOMMENDED CABLE DRESSING...
  • Page 6 TVSS OWERWARE PLUS ® ASTER Schematic Connection Diagrams 120/240V SPLIT PHASE 3 W THREE PHASE 4W WYE THREE PHASE HIGH LEG DELTA NOTE: L2 is designated as the "HIGH LEG" * An optional breaker or disconnect may be used for overcurrent protection of the interconnecting wires.
  • Page 7: Installation

    TVSS OWERWARE PLUS ® ASTER Optional Surge Counter NSTALLATION PERATING NSTRUCTIONS 1. Disconnect power to ZoneMaster PLUS by pulling on disconnect. ® 2. Attach the black and white pair wire across the surge module by removing the screws and attaching the lugs from the counter.
  • Page 8: Maintenance

    Do not overtighten. NOTE: No customer serviceable parts inside. Opening module WILL void Warranty Copyright 1999© By Powerware Corporation All Rights Reserved Printed in U.S.A. 801517 Rev. A 3-7-00...