Installing the AORUS RGB Memory Armor
(Note)
Refer to the illustrations below to install the AORUS RGB Memory Armor.
Step 1:
Remove the connector cap from the LED_DDR header on the motherboard. Then
connect the power cable on the
side of the AORUS RGB Memory Armor to the LED_DDR header. (Note: Always replace the connector cap when the AORUS
RGB Memory Armor is not installed.)
Step 2:
Align the AORUS RGB Memory Armor with the motherboard in the direction as indicated below and secure it
with the three included screws (M2*6).
Screw
(M2*6)
(Note)
The AORUS RGB Memory Armor is only compatible with the AORUS Memory DDR5 Module.
- 18 -