Tools And Materials; Before You Begin - Kohler K-1675 Installation Manual

Tools and Materials

Drill
Drill Bits,1/4"
C-Clamps
& 5/16"
Open End Open End
Box Wrench Wrench
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler
Company.

Before You Begin

CAUTION: Risk of product damage. If extensive shimming is required, all dimensions must be
checked and confirmed. Take extra care when creating centerlines and marking the valve hole and
showerhead location.
Read all instructions before you begin.
There are two sets of instructions in this installation guide, the receptor and shower wall
installation, and receptor only installation. Refer to the appropriate section.
Before removing the old unit, inspect your Kohler shower walls and receptor for damage.
Observe all local plumbing and building codes.
If you are remodeling, measure the existing framework before removing the old fixture to ensure the
new unit will fit. If needed add or move studs to create the proper stud configuration that is shown.
To prevent damage, keep the shower components in a safe place until you begin the installation.
Do not install the shower over open floor joists.
Make sure there is sufficient access to move the module into the installation location.
Avoid flexing the sidewalls to prevent damage to the module.
Insulate all exterior walls before installation.
If ceiling height allows, it is recommended that the showerhead be mounted above the shower wall.
The Kohler Model K-704516 shower door must be used with this shower module.
Consult all applicable instructions for accessories and shower doors before installing.
Position the rough drain according to the roughing-in dimensions.
Consult all applicable instructions for options and accessories before beginning this installation.
1036225-2-B
Level
Claw
Hammer
Pencil & Felt
Shims Tip Marker
Jigsaw
Socket Wrench
W/Sockets
Tape
Measure
Square
Safety Glasses
Caulk Gun
2
Masking Silicone
Tape Sealant
Plus:
• Conventional woodworking
tools and material.
• Drop Cloth
• 2x4's or 2x6's
• Hole saw or jigsaw with fine
tooth blade (32 teeth per
inch)
• #6 Large-head galvanized
nails
Kohler Co.