Table of Contents
Advertisement
Available languages
Available languages
table of contents
EN
1.0
2.0
2.1
burner installation
2.2
2.3
2.4
3.0
3.1
3.2
4.0
4.1
overview
note:
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel Ltd. reserves
the right to change or modify any information within this manual at any time without notice. Changes, other
than editorial, are denoted by a vertical line in the margin.
WARNING:
!
which are known to the State of California to cause cancer, and chemicals including carbon
monoxide, which are known to the State of California to cause birth defects or other reproduc-
tive harm. For more information, go to www.P65Warnings.ca.gov.
1.0 general information
This burner and log assembly is approved for use with the GD19N/P-2 gas appliances only. It is not approved for
use as a stand alone appliance or in conjunction with any other appliance.
2.0 installation
2.1
burner installation
note:
Before installing the burner, adjust the air shutter for the desired fuel and install the fuel conversion kit if re-
quired (see "venturi adjustment" section).
A.
Install the burner assembly, ensuring that the venturi tube fi ts
over the orifi ce.
B.
Secure using screws (supplied).
2
W415-2781 / 10.09.19
This product can expose you to chemicals including lead and lead compounds,
LOCATING
PINS
ORIFICE
LOCATION
BURNER
ASSEMBLY
SCREW
LOCATIONS
2
2
2
3
4
4
5
5
5
6
7
Advertisement
Chapters
Table of Contents
