Advertisement
Data and installation
Installation
a)
Check the contents of the package:
Component
Keyswitch Interface
assembly (red / blue)
Earth Strap
Operating Key
Opening Key
Long Screw
i
Instruction leaflet
Blue Back box supplied
THIS WAY UP
with Blue keyswitch
interface assembly
b)
The keyswitch assembly may be mounted on a
standard electrical box or on the backbox.
c)
Feed the fire rated cables through the entry holes and
mount an electrical box or the red/blue back box to an
even wall surface using suitable fixing.
"
When semi flush fixing the keyswitch
assembly a standard electrical box must first be flushed
into the wall before the keyswitch assembly is fitted.
Keyswitch assembly
Loop
Loop
In
Out
d)
Terminate each cable entry at the
back box. Use the earth strap or
the earth point in the back box to
maintain loop cable earth
continuity. Connect the loop cable
to the terminals.
e)
Disengage front cover from the
keyswitch assembly using the end of the opening key
'E' and lift out the cover from the bottom edge.
f)
Secure the keyswitch assembly to the back box using
the 2 long screws supplied.
Gent by Honeywell reserves the right to revise this publication from time to time and make changes to the content hereof without
obligation to notify any person of such revisions of changes.
Hamilton Industrial Park, Waterside Road, Leicester LE5 1TN, UK
by Honeywell
Telephone +44 (0) 116 246 2000
2
Quantity
1
1
2
1
2
1
1
Keyswitch assembly
Loop
Loop
In
Out
E
S4-34XXX range - Keyswitch I/F & MCP
g)
Hook the front cover onto the top edge of the
keyswitch unit and then push the bottom edge down
until it click shut. Check both hooks on the top of the
front cover are locked onto the keyswitch assembly.
Operation
To operate the keyswitch insert the operating key into the
keyhole 'J' and turn clockwise to the stop position,
LED 'K' is
flashing. The green LED 'I' gives an operating
indication.
Apply the reverse procedure to return the keyswitch to a
normal operating position.
I
J
K
O
I
Label
When using the blue keyswitch interface to control plant
ensure the unit is labelled to describe what is being
controlled by the keyswitch.
Transparent cover
32 x 12mm
stick on label
Disable
Zone n
It is suggested that an A4 sheet white paper label
32 x 12mm is used, such as the one from RS, part number
RS495 385. The required text can be printed onto the label.
The label is stuck centrally inside the aperture behind the
transparent cover. Ensure LEDs remain visible and are not
covered by the label.
At the end of their useful life, the packaging,
product and batteries should be disposed of
via a suitable recycling centre and in
accordance with national or local legislation.
WEEE Directive:
At the end of their useful life, the packaging,
product and batteries should be
disposed of via a suitable recycling centre.
Do not dispose of with your normal household waste.
Do not burn.
4188-910.01_S4-348XX range of keyswitch I/F & MCP
the red
O
Normal
I
O
Active
I
Website: www.gent.co.uk
Fax (UK): +44 (0)116 246 2300
Advertisement
