Bosch GWS10-450 Operating/Safety Instructions Manual page 18

INSTALLING MASONRY TYPE 1A/41
CUTTING GUARD
1. Use tool adjusted as show in figures 11
and 12.
2. Unplug tool from power source.
3. Unscrew and remove side handle.
4. Slide dust extraction guard on spindle
neck.
5. Rotate attachment until stability bracket
and hole for side handled are aligned.
6. Screw in side handle to secure stability
bracket between the tool housing and
handle.
7. Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
Lock Nut
Backing
Flange
Assembly
Dry
Diamond
Wheel
Spindle
INSTALLING DRY DIAMOND WHEEL
1. Place the backing flange on the spindle.
Turn flange until it locks with the base of
the spindle.
2. Place the dry diamond wheel onto the
spindle and align the arbor hole of the
grinding wheel with the shoulder of the
backing flange.
3. Thread on the lock nut and tighten it with
supplied lock nut wrench while holding
spindle lock.
TO REMOVE: Reverse procedure.
FIG. 13
Spindle
Backing Flange
Dry
Diamond
Wheel
-18-
(Fig. 13)
Dry
Diamond
Wheel
Spindle
Lock
Nut
Lock nut
Backing
Flange