Pyle LPTS25X2 Quick Start Manual

PLPTS25X2
Universal Device Holder (Pair)
PREPARATION:
Remove the following parts from the box and identify all the parts:
(4) Upper Supports
ASSEMBLING INSTRUCTIONS
1. Start by removing the end caps from the
two stabilizer rods.
2. Assemble the left/right support brackets.
Take one side of the upper supports and
match it with the corresponding side
lower support (the lower supports feature
anti-slip grip pad on the bottom) - Figure A.
Align the mounting holes at the desired
height and position the Screw Knobs
through the supports (ensure not to over-
tighten). -Figure B.
NOTE: The Stabilizer Bars MUST be
positioned at least 2 holes apart.
3. Repeat steps 1 & 2 above to assemble the
other side of the stand's support bracket
aligning the correct heights of the stabilizer
rods.
www.PyleUSA.com
Laptop/Notebook Stand
(4) Lower Supports
(4) Stabilizer Rods
(8) Screw Knobs
Figure A
Figure B