Miele KM 6520 FR Operating And Installation Instructions page 66

Installation
Securing the spring clamps – natural
stone worktops
You will need heavy-duty double-sided
adhesive tape (not included with the
hob) to fasten the spring clamps.
The exact positioning of the spring
clamps is shown in the individual hob
diagrams.
 Attach the adhesive tape  along the
top edge of the cut-out in the
positions shown in the hob
illustration.
 Position the spring clamps on the top
edge of the cut-out and press them
firmly into place.
 Coat the side edges and the lower
edge of the spring clamps with
silicone.
66
Install the hob
 Feed the mains connection cable for
the hob down through the worktop
cut-out.
 Position the hob in the worktop cut-
out.
 Using both hands, press down evenly
on the sides of the hob until it clicks
into position. When doing this make
sure that the seal of the appliance sits
flush with the worktop on all sides.
This is important to ensure an
effective seal all round.
If the seal does not meet the worktop
correctly on the corners, the corner
radius (≤ R4) can be carefully scribed
a
to suit.
Do not use any additional sealant
(e.g. silicone) on the hob.
 Connect the hob to the mains.
 Check that the hob works.
The hob can only be removed using a
special tool.