Setting Remote Control Codes That Are Not Stored In Quick Click - Sony STR-DA5500ES Operating Instructions Manual

Setting remote control
codes that are not stored
in Quick Click
1
Press MENU.
The menu is displayed on the TV screen.
2
Press V/v repeatedly to select
" Settings," then press
b.
3
Press V/v repeatedly to select
"Quick Click," then press
b.
4
Press V/v repeatedly to select
"Source Component," or
"Common Component," then
press .
5
Press V/v repeatedly to select
the component you want, then
press .
6
Press V/v repeatedly to select
"Learn Mode," then press
7
Press V/v repeatedly to select
the code number you want to
store as the new command,
then press
8
Keep pressing the
corresponding button on the
remote of the component to be
programmed while pointing the
remote toward the receiver's
remote sensor until
V/v/B/b,
"Complete" is displayed on the
TV screen.
MENU
Remote sensor
"Test" is selected automatically after few
seconds when the registration of a new
code is completed.
9
Press
or
The operation test of the programmed
code is started.
Proceed to step 10 if you will not perform
or the operation test.
10
Press V/v/B/b repeatedly to
select "Finish," then press
Note
The display window is turned off while the receiver
is registering the new code.
.
About 5 cm - 10 cm (2" - 4")
.
continued
.
.
167 GB