BellSouth Premium Systems BS-373 Owner's Manual Installation And Operating Instructions page 26

All manuals and user guides at all-guides.com
ME N U S E T T IN GS
PBX Mode
I f y ou are using a PBX ( Private Branch E x change) telephone sy stem , y ou m ay be
required to dial an ex ternal access code, such as [8] or [9] , prior to reaching an outside
line. Follow the steps below and enter that code in the PBX PREFI X f ield. This code
will then be added to all stored num bers upon dialing.
PBX MODE
O. K. EXI T
L1 PBX PREFIX:
EXI T
SAVE
Note: The phone will autom atically screen all Pre-dial num bers prior to dialing if PBX
Pref ix is set. Enter the access code and the phone num ber y ou wish to dial, the
phone will autom atically insert a ' pause' af ter the f irst digit when dialing the num ber.
On the contrary , if the f irst digit is not the access code, the sy stem will classif y it as an
internal call and dial the display ed num ber only .
New Cal l Lam p
The Message W ai t i ng I ndi cat or / New Cal l Lam p will f lash when there are new or
unviewed Caller I D entries in call log if the lam p is switched on.
NEW CALL LAMP
O. K. EXI T
NEW CL LAMP IS OFF
EXI T
SAVE
Press [MENU] .
Using [▼ ] / [▲ ] to access " PBX MODE" .
Press [O.K.] to enter into the selection.
Using [▼ ] / [▲ ] to select " L1 PBX Pref ix " or " L2 PBX
_
Pref ix " .
Enter the code using num eric key s " 0 - 9" .
Press [SAVE ] to conf irm , and then press [EXI T] to
return to stand-by .
Press [MENU] .
[▼ ] / [▲ ]
Using
Press [O.K.] to enter into the selection.
[▼ ] / [▲ ]
Using
OFF.
Press [SAVE ] to conf irm , and then press [EXI T] to
return to stand-by .
25
access " NEW CALL LAMP" .
t o
switch the New Call Lam p ON or
t o