Trouble Shooting - LG LREL6323 Series Service Manual

PROBLEMS
Oven not operating.
Oven element does not
heat.
Surface element barely heats
Surface element will not heat
Higher than low-medium
Frequent cycling of surface
Element or warming zone
"HS" (Hot surface)Warning
message does not light up
Oven light fails to operate.
Oven does not begin clean
cycle
Oven stop for Self clean
cycle
1
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes

TROUBLE SHOOTING

POSSIBLE CAUSES & FAULTS
element or terminal block.
This is normal
door switch
10-1
SOLUTIONS
T
Refer to the page 9-1~9-3
Verify power is present at unit.
Verify that the circuit breaker is not
tripped
r.
Repair or replace wiring
(see wiring diagrams).
Test and/or replace element.
T
Verify all connections are clean and tight,
replace broken wires
T
Test and/or replace element.
240-volts. Of necessary, electrician should
repair cause for low line voltage
The element will cycle on and off to
maintain the heat setting
T
Test and/or replace door switch
switch
Shut off power to oven for five minutes by
switching off circuit breaker.
Reset circuit breaker and try oven again.
Test door switch and check the point of
contact between door and door switch
y.