Related Manuals for Russound DTI-1
Summary of Contents for Russound DTI-1
- Page 1 DTI-1 Instruction Manual Doorbell Telephone Interface T elephone Remote T ele- T elephone Power Plug Ring On/Off Trigger DoorBell Line (In & Out) 16V AC...
-
Page 2: Table Of Contents
1. Read Instructions - All the safety and operating instructions should be 2. Location of the DTI-1 - Do not expose the DTI-1 to direct sun light or read before the appliance is operated. heating units as the DTI-1 internal components temperature may rise 2. -
Page 3: Introduction
2. INTRODUCTION 4. FEATURES Congratulations on your purchase of the DTI-1 Doorbell The DTI-1 Doorbell Telephone Interface is a telephone based Telephone Interface, a system that offers enhanced doorbell system that provides the system user with the capability security while providing unparalleled convenience. The system of communicating with a door speaker from any installed tele- can be used with or without a doorbell. -
Page 4: Connections
RJ31X (CA38A) To second TDB-1 Data Jack Note: Center pair are phone (supplied) or other device such line into DTI-1. Outer pair as the TPM-1 paging are to the phones module RJ11 Modular Wire (Supplied with Unit) – Power Supply Used to activate devices (ex. -
Page 5: Installation
HOLE Figure 1 shows the detail of the connectors located on the front of the unit. Figure 2 shows interconnection of the DTI-1 with other parts that form the system. Installation of the system requires that the installer install a 4-conductor wire (24 AWG) be installed from the location of the door speaker unit to the location of the system control unit. -
Page 6: Operation
7. OPERATION 1. If your doorbell rings or you hear the unique DTI-1 ring signal, pick up any telephone in the house within two minutes. You can now talk to the person at the entrance. 2. If two minutes has expired, then pick up any telephone and press on the touch tone keypad on your telephone. -
Page 7: Trouble Shooting
11. WARRANTY TDB-1 Port When the DTI-1 system is using the TPM-1 The Russound DTI-1 and TDB-2 are fully guaranteed for One (1) year (RJ-11) Paging Module and there is no TDB-1 being from the date of purchase against all defects in materials and workman- used, a 300 Ohm resistor is required for the ship. - Page 8 5 Forbes Rd. Newmarket, NH 03857, USA ☎ 603.659.5170 • Fax 603.659.5388 e-mail: tech@russound.com Come visit us at: 062501...