Frigidaire FEB798CCSE Installation Instructions Manual page 6

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
B. 30", Single and Double Ovens
The wall oven can tip when the
door is open. The mounting
brackets supplied with the wall oven must be
attached to the cabinet and the appliance to
prevent tipping of the wall oven and injury to
persons.
Mounting Brackets Installation Instructions
1. Unpack the wall oven and find the 2 mounting
screws included in the literature package. The
door may be removed to facilitate handling (see
the Owner's Guide for instructions).
2. The mounting brackets are temporarily installed
under the decorative side trims of the oven when
shipped (see Figure 8 or 9 ). Remove the mounting
brackets from the unit side frame using a No. 2
Robertson® screw driver (square drive preferred,
however a No. 2 Phillips® or Quadrex® screw driver
can also be used). Open the door to remove the
screws, located at the upper end of the side trim.
3. Insert the unit into the cabinet opening. Slide unit
3
inward leaving 1 " (3.5 cm) clearance between
/
8
the oven decorative trim and cabinet. Pull the
armored cable through the hole in the floor and
toward the junction box while moving the appliance
inward. Use the second set of holes in the side frame
of the unit as a guide to find the position of the
mounting brackets on the sides of the cabinet
opening. Mark the position of the mounting brackets
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
28 1/16" (71.3 cm) Min.
29 5/8" (75.2 cm) Max.
Mounting Brackets
22"
(55.9 cm)
21 1/4"
(54.0 cm)
Wood Shims (If Needed)
* Recommended Cutout Width is 28 1/2" (72.4 cm)
Figure 8
30" SINGLE OVEN
* Recommended Cutout Width is 28 1/2" (72.4 cm)
4. Pull out the oven approximately 1 foot (30.5 cm)
27 1/4"
(71.8 cm) Min.
28 7/8"
(73.3 cm) Max.
6
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
28 1/16" (71.3 cm) Min.
29 7/16" (74.8 cm) Max.
Mounting Brackets
42 3/4"
(108.6 cm)
42"
(106.7 cm)
Wood Shims (If Needed)
Figure 9
30" DOUBLE OVENS
as shown in Figure 8 or 9.
away from the cabinet. Reposition each bracket on
the cabinet and drill 1/8" pilot holes. Fasten the
brackets in place using the 2 screws supplied (#10 x
1
1 / " long).
4
If needed, add wood spacers at the mounting
bracket locations to reduce the cabinet opening to
1
28 " (72.4 cm).
/
2
Now push the unit in and against the cabinet, then
attach the unit to the mounting brackets using the 2
screws removed earlier from the side frame.
49 1/8"
(124.8 cm) Min.
49 3/4"
(126.4 cm) Max.