Beckett CB25 Series Owner's Manual

AUTOMATIC CONDENSATE UNIT
Model: CB25*
23' LIFT
RULES FOR SAFE OPERATION
1. Carefully read the Owners Manual and rules for safe operation.
2. All wiring must conform to local codes. Use the National Electric Code if local code is nonexistent.
3. CAUTION! To reduce risk of electric shock disconnect from power supply before servicing, pull the plug on models which have
plug-in connections.
4. Do not handle the pump with wet hands or when standing in water as fatal shock could occur. Disconnect main power before
handling unit for ANY REASON!
5. Protect the power cable from coming in contact with sharp objects.
6. Do not kink power cable and never allow the cable to come in contact with oil, grease, hot surfaces or chemicals.
7. Make certain that line voltage conforms to the voltage specified on motor and nameplate.
8. WARNING! To reduce risk of electrical shock, connect only to a properly grounded grounding type receptacle.
Select a location for the pump. It should be
as near as possible to the air conditioning
coil. The pump must be level. The inlet
hole must be below the coil drain.
Carefully unpack the pump. Remove the
switch cover. Check each float rod for "free"
action.
Owners Manual
Keep For Future Reference
INSTALLATION OPERATION
CAUTION: Read rules for Safe Operation and Installation.
*Suffix denotes features
Example: CB25
Base Model
1 = 115V; 2 = 230V: 4 = 460V; 7 = 277V
INTRODUCTION
INSTALLATION
CB25
CB50
BECKETT CORPORATION
Irving, Texas
www. beckettpumps.com
Phone: 972-871-8000
Toll Free: 1-888-BECKETT
Fax: 972-871-8888
© 2007 BECKETT CORPORATION All Rights Reserved
1 UL HT
UL Listed
Voltage:
PRIMARY SWITCH
FLOAT
TERMINAL BLOCK
Model: CB50*
48' LIFT
High Temperature Model, for use with
maximum 190° F water.
COVER
OUTLET
Y8611 Rev. E
SAFETY SWITCH
MOTOR
INLET
STAND
TANK