Table Of Contents; Introduction - Husqvarna 435 Operator's Manual

Introduction................................................................... 10
Safety............................................................................11
Assembly...................................................................... 15
Operation...................................................................... 15
Maintenance................................................................. 21
Product description
The Husqvarna 435, 440 are chainsaw models with a
combustion engine.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Product overview
(Fig. 1)
1. Cylinder cover
2. Air purge bulb
3. Start decal
4. Start/stop switch
5. Rear handle
6. Information and warning decal
7. Fuel tank
8. Adjuster screws carburetor
9. Starter rope handle
10. Starter housing
11. Chain oil tank
12. Product and serial number plate
13. Felling direction mark
14. Front handle
15. Chain brake and front hand guard
16. Muffler
17. Saw chain
18. Bar tip sprocket
19. Guide bar
20. Spiked bumper
21. Chain catcher
22. Chain tensioning screw
23. Clutch cover
24. Right hand guard
25. Throttle trigger
26. Throttle trigger lockout
27. Operator's manual
28. Combination wrench
29. Guide bar cover
10
Contents
Troubleshooting............................................................ 28
Transportation and storage...........................................29
Technical data.............................................................. 29
Accessories.................................................................. 30
Warranty....................................................................... 32

Introduction

Intended use
This chainsaw for forest service is designed for forest
work such as felling, limbing and cutting.
Note:
National regulations can set limit to the
operation of the product.
Symbols on the product
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig. 11)
WARNING! Be careful and use the
product correctly. This product can cause
serious injury or death to the operator or
others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Use 2 hands to operate the product.
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an
object.
Other approved bar and chain
combinations in the operator's manual.
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
Computed kickback bar stopping angle
with actuated chainbrake, CKA wb.
Warning! Kickback can occur when the
guide bar tip touches an object. A
kickback causes a lightning fast reverse
reaction that throws the guide bar up and
1270 - 005 - 21.06.2021