Frigidaire FAS256N2A Owner's Manual
Heavy duty air conditioner with variable speed electronic control
Hide thumbs
Also See for FAS256N2A:
- Product information and technical manual (20 pages) ,
- Factory parts catalog (6 pages)
Related Manuals for Frigidaire FAS256N2A
Summary of Contents for Frigidaire FAS256N2A
-
Page 1: Air Conditioner
OWNER’S GUIDE READ AND SAVE THESE INSTRUCTIONS HEAVY DUTY AIR CONDITIONER VARIABLE SPEED ELECTRONIC CONTROL P/N 309000855 (11/03) -
Page 2: Warranty
Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this war- ranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this war- ranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer. -
Page 3: Table Of Contents
On some models, remove the filter and look at the bottom edge of the air conditioner behind the front grille for the model and serial numbers. Reading these numbers may be easier by using a flashlight or by removing the cabinet front as instructed under “Care... -
Page 4: Important Safety Instructions
• If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass first. If the window is a triple-track type with a screen panel included, remove the screen completely before installation. -
Page 5: Using Air Conditioner
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. To begin operating the air conditioner, follow these steps: 1. Plug in the air conditioner. (To prevent electrical hazards, do not use an extension cord or an adapter plug.) 2. Set the exhaust vent to the CLOSED position. - Page 6 Air Conditioner Features (continued) TO TURN UNIT ON: TO CHANGE TEMPERATURE SETTING: Note: Tap or hold either up( ^ ) or down(v) button until the desired temperature is seen on the display. This temperature will be automatically maintained anywhere between 60 temperature, see “Operate in Fan Only.”...
- Page 7 Air Conditioner Features (continued) TO USE AUTO COOL FEATURE: Note: Fan speed starts at HI and adjusts to a slower and slower speed as the room temperature indictates. For example, if the room doesn't get too warm it will stay at the slowest speed. If the room temperature rises quickly, such as a door being opened, it will automatically go to the highest speed.
- Page 8 Air Conditioner Features (continued) TIMER: DELAY START/STOP FEATURE: Note 1: For Delay Stop, the unit must be in the ON position. Note 2: For Delay Start, the unit must be in the OFF position. First,PRESS TIME BUTTON Then, to adjust timer setting, tap or hold the UP arrow(^) or DOWN arrow (v) to change the delay time by .5 hour increments up to 10 hours, then by 1 hour increments up to 24 hours.
- Page 9 Air Conditioner Features (continued) CLEAN AIRE FEATURE (on some models) Note: When this feature is “ON,” the ion generator is energized and will help to remove pollen and impurities from the air, and trap them in the filter. REMOTE SENSING FEATURE...
- Page 10 Figure 2 (FRESH AIR) Fresh Air Vent Control The Fresh Air Vent allows the air conditioner to: 1. Recirculate inside air — Vent Closed (see Fig. 1) 2. Draw fresh air into the rom — Vent Open (see Fig. 2) 3.
-
Page 11: Care And Cleaning
• Or, instead of washing you may vacuum the filter clean. Cabinet Cleaning • Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of warm water and mild liquid dishwashing detergent. -
Page 12: Avoid Service Checklist
Window vibration — poor installation. Refer to installation instructions or check with installer. Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to installation instructions — check with installer. Unit removing large quantity of moisture from humid room. This is normal during excessively...