Uncrating - True GDM Installation Manual

Installation (cont.)

Uncrating

Tools Required
• Adjustable wrench
• Phillips screwdriver
• Level
The following procedure is recommended for uncrating the unit:
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with
the freight carrier if there is damage.
NOTE: DO NOT remove the shipping bracket (glass swing
doors; fig. 2) or the shipping blocks (glass slide doors; fig. 3)
until the unit is installed in its final location. Do not discard;
use the bracket/blocks when next moving the cabinet.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 4.
NOTE: Move the unit as close as possible to the final location
before removing the wooden skid. Some models may require
removing the front and/or rear grill/cover to access the
shipping bolts.
3. If leveling legs or castors will not be used, remove the
cabinet from the wood skid and set the skid aside.
NOTE: DO NOT lift the cabinet by the counter tops, doors,
drawers, or grills.
If leveling legs or castors will be used, rotate the cabinet on
the skid (see fig. 5) and see the installation instructions on
pages 7-8.
NOTE: Remember to leave cabinet upright for 24 hours before
plugging into a power source. Keys for cabinet with door locks are
located in the warranty packet.
– Units may pose a tipping hazard
WARNING
while uncrating, during installation, or when
moving the unit.
Fig. 1. Remove the exterior
packaging.
Page 6 of 22
GL ASS D OO R M ER CH A ND IS ER S
Fig. 2. Remove the glass swing door shipping bracket, if so equipped. Do not discard.
Fig. 3. Glass slide door shipping block locations. Remove if so equipped and do not
discard.
Fig. 4. Shipping bolt locations.
Fig. 5. When lifting unit, do not
use counter tops, doors/drawers,
or grills as a lifting point.
03/19/2021
truemfg.com
TEC_TM_105 REV. A