Advertisement
Wall Sleeve Brands:
1
2
2
4
5
6
7
10
#9 White-Westinghouse or Frigidaire
1. If the wall sleeve does not have a rear grille or louvered panel, install
the plastic grille panel from the kit. The plastic grille panel is mounted
to the inside of the wall sleeve at the rear flanges. There are (4)
plastic nuts in the flanges of the wall sleeve. If your sleeve is missing
these nuts or they are damaged, replacement nuts and grille
mounting screws are supplied with the kit. The nuts are installed
from the inside of the sleeve and are pressed into the square holes
of the rear flanges. Place the grille against the rear flanges and use
the (4) washer screws to secure the grille to the sleeve.
9
1
⁄
"‹
2
2. Attach the (2) 4
sleeve as shown in the illustration.
3. Attach 1"x 3/4"x 14"long seal to the inside of the grille panel.
3
4. Cut the 1/8"x 4
Slide the plastic divider in the slots of the (2) foam blocks.
5
5. Cut to fit (1) 1
6. Attach (2) 1
6
shown. Seals should be flush with front portion of the 4
1
1
⁄
"foam blocks which holds the plastic divider.
2
7. Install the new unit into the wall sleeve.
Attach the ground wire to the unit as shown.
8. Install the 1"x 1
A flat bladed screwdriver or putty knife is recommended.
8
1
⁄
"x 3
1
⁄
"x 1
1
⁄
"foam blocks to the inside of the wall
2
2
2
1
⁄
"x 14
1
⁄
"long plastic divider to 13"long.
2
2
1
⁄
"x 1
1
⁄
"x 26
1
⁄
"long seals as shown.
2
2
2
1
⁄
"x 1
1
⁄
"x 14"long seals to 13
2
2
1
⁄
"x 84"long stuffer seal between the wall sleeve and the unit.
2
8
9. Assemble and install the Trim Frame.
(see Trim Frame)
22"Deep
1
⁄
"install the seals as
2
1
⁄
"x 3
1
⁄
"x
2
2
Advertisement
