Advertisement
IN230000AV
REGULATOR
AIR INLET (OIL HERE
DAILY IF NOT USING
AN AIR TOOL OILER)
SPEED ADJUSTMENT
The impact wrench should never be used to set torque.
Use a torque wrench to set the torque. Models TL1002,
TL1017 and TL1049 are equipped with regulators for
speed adjustment (See Figure 2).
To remove nuts, set the regulator to the maximum
setting. To install nuts, set the regulator to the minimum
to medium setting. Do not overtighten the nuts.
AIR HOSE
Figure 2 illustrates a recommended air hose hook-up.
NOTE: It is not recommended to install a quick coupler
between the impact wrench and the leader (whip) hose
(See Figure 2).
Using fittings or air hoses which are too small can create
a pressure drop and reduce the power of the tool. For
models TL1002, TL1017 and TL1049, using 3/8" (I.D.)
fittings with 1/4" NPT threads are recommended. Most
compressors are shipped with a short, 1/4" I.D. hose.
For proper performance and more convenience, use a
3/8" I.D. hose. Hoses longer than 50 feet should have a
1/2" I.D.
MODEL
AVERAGE
#
SCFM & PSI
TL1002
5.1 @ 90
TL1017
2.4 @ 90
TL1049
2.5 @ 90
MODELS TL1002, TL1017 AND TL1049
Operation (Continued)
QUICK
QUICK
COUPLER
CONNECTOR
LEADER
(WHIP)
HOSE
DO NOT INSTALL A
QUICK COUPLER HERE
Figure 2 - Air Hose Hook-up
Specifications & Performance
MAX
MAX
RPM
TORQUE
7000
230 ft/lb
1/4" NPT (Female)
10,000
75 ft/lb
1/4" NPT (Female)
10,000
75 ft/lb
1/4" NPT (Female)
QUICK
OILER
COUPLER
(OPTIONAL)
QUICK
REGULATOR
CONNECTOR
(OPTIONAL)
AIR
HOSE
AIR TOOL MANUFACTURERS RECOMMEND THAT AN AIR FIL-
TER AND OILER BE USED TO INCREASE THE LIFE OF THE TOOL.
!
NEVER CARRY A TOOL BY THE HOSE OR PULL
THE HOSE TO MOVE THE TOOL OR A COMPRES-
SOR. KEEP HOSES AWAY FROM HEAT, OIL AND
SHARP EDGES. REPLACE ANY HOSE THAT IS
DAMAGED, WEAK OR WORN.
STORAGE
The impact wrench must be lubricated before storing.
Follow the air motor lubrication instructions with an
exception to step 4. Only run the impact wrench for 2
to 3 seconds instead of 20 to 30 seconds because more
oil needs to remain in the impact wrench when storing.
Technical Service
For information regarding the operation or repair of this
product, please call 1-800-543-6400. If you are calling
from Ohio or outside the continental United States,
please call collect, 1-513-367-1182.
AIR
INLET
DRIVE
1/2" Sq
3/8" Sq
3/8" Sq
– 3 –
FILTER
AIR SUPPLY
DRAIN (WATER TRAP)
WARNING
!
EXTENDED
WEIGHT
ANVIL
5 lb
2 lb
N/A
3 lb
NA
NA
Hide quick links:
Advertisement
