What To Do In The Event Of A Fault - Siemens KF 86N Series Installation Instructions And Instructions For Use

en

What to do in the event of a fault

3 What to do in the event of a fault
B efore you call Customer Service, use this table to check whether you can rectify the fault yourself.
W h a t t o d o i n t h e e v e n t o f a f a u l t
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has been tripped.
The power has failed.
Display shows E....
Electronics have detected a fault.
The alarm off button flashes and a warning signal sounds.
Refrigerator compartment, cool-fresh compartment or freezer com-
partment is open.
Ventilation openings are covered up.
Large quantities of fresh food were placed in the appliance.
The temperature in the refrigerator compartment, cool-fresh compart-
ment or freezer compartment is too warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
56
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 45
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Connect mains plug.
Check the fuses.
Check whether the power is on.
Call Customer Service.
~ "Customer Service" on page 57
Press alarm off button. The alarm is switched off.
Close the appliance.
Clear the ventilation openings.
Do not exceed maximum freezing capacity.
Press alarm off button. After the alarm off button is pressed, the
warmest temperature reached in the freezer compartment is dis-
played for 5 seconds. The display stops flashing.
Start the appliance self-test.
~ "Appliance self-test" on page 57
When the programme has ended, the appliance switches over
to normal operation.