Ports - Huawei FusionServer Pro 1288X V5 Technical White Paper

Huawei FusionServer Pro 1288X V5 Server
Technical White Paper
Indicator
UID indicator
PSU indicator

5.2.3 Ports

Port Positions
Figure 5-6 Rear view
1
Issue 02 (2020-04-20)
Description
The UID indicator helps identify and locate a device.
● Off: The device is not being located.
● Blinking blue: The device has been located and is
differentiated from other devices that have also
been located.
● Steady blue: The device is being located.
NOTE
You can turn on or off the UID indicator by pressing the UID
button or remotely running a command on the iBMC CLI.
● Off: No power is supplied.
● Blinking green at 1 Hz:
– The input is normal, and the server is standby.
– The input is overvoltage or undervoltage.
– The PSU is in deep hibernation mode.
● Blinking green at 4 Hz: The firmware is being
upgraded online.
● Steady green: The power input and output are
normal.
● Steady orange: The input is normal, but no power
output is supplied.
NOTE
The possible causes of no power output are as follows:
● Power supply overtemperature protection
● Power output overcurrent or short-circuit
● Output overvoltage
● Short-circuit protection
● Device failure (excluding failure of all devices)
LOM ports
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Description
2 Ports for OCP 2.0
mezzanine card 1
15