Epson DX5 X 1 Calibration And Maintenance page 12

After input the value, print the alignment again. And observe if the "0" position is the best or not. If not, repeat the
above procedure until the best result come out.
4. Bi-Dir offset
Bi-Dir offset is to make sure there is no bi-difference while using different speed to print. Bi-Dir offset will be set
for different printing speed.
8
16
If the "0" position is not the perfect matching one, then we have to adjust the value on the software. Go to Option
– Calibration Calibration Calibration Calibration - Bi-Dir Bi-Dir Offset Bi-Dir Bi-Dir
Repeat the test until the "0" is facing each other perfectly.
5. Step offset
The Step offset locates on Option
:
To adjust the step offset, firstly adjust the
automatically. And slightly adjustment is needed according to actual printing.
4
OK
Offset Offset Offset
Input the value here. This
value is accumulated. Press
"Print" to print the test
pattern.
Option Option Calibration Calibration
Option – Calibration Calibration – Step
Input the offset
value
here.
Base
Base Base Base Step,
-4
0
NG
Step Step Offset Offset
Step Offset Offset
Step,
Step, Step, then the value of other pass will be calculated
12
-8 -16
Option Option Option