Changing The Bulb For Interior Lighting - AEG LAVATHERM 59800 User Information

Problem
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The spe-
cial bulb can be obtained from the Customer Care Department, ET no.
112 552 000-5.
3
Important: When the appliance is switched on, the interior lighting
switches itself off after 5 minutes when the door is open.
1
Warning: Do not use standard bulbs! These develop too much heat and
may damage the appliance.
1
Warning: Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the
loading aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
1
Warning: For safety reasons, the cover must be screwed down tightly.
If this is not done, the dryer must not be operated.
24
Possible cause
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room tem-
perature. Temporary switch-
ing off of the compressor to
avoid overload.
Remedy
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.
Automatic process, there is no
fault with the appliance. If
possible, lower the room tem-
perature.