Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Insert the solid-state drive at a 45-degree angle into the system board.
3. Press the other end of the solid-state drive down and replace the screw (M2x2.5) that secure the solid-state drive to the system
board.
Next steps
1. Install the
single-graphics card
2. Install the
left-side
cover.
3. Follow the procedure in
Single-graphics card
Removing the single-graphics card
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
cover.
About this task
The following images indicate the location of the graphics card and provides a visual representation of the removal procedure.
48
or
dual-graphics
card, as applicable.
After working inside your
Before working inside your
computer.
computer.