Table of Contents
Advertisement
TIPS FOR BEST RESULTS
•
Ensure your skin is dry. Always hold the shaver at right angles to the skin so that all
three heads are touching the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid damage to the rotary heads.
SHAVING WITH SHAVING GEL
•
Follow the same instructions as dry shaving, noted above in the Shaving section, if
using with gel.
•
Caution: After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance. We recommend you clean
your appliance after each use.
•
Ensure the appliance is switched off and unplugged from the mains before
cleaning.
1.
Open the shaver head by pressing the release button (Fig. A).
2.
Empty out any hair clippings.
3.
Pull the shaver head upwards to remove it from the body (Fig. B).
4.
Locate the centre arrow and slide the retainer in the opposite direction to release it.
Once released, lift it out of the shaver head (Fig. C). Make a note of the correct
orientation of the retainer to make refitting easier.
5.
Carefully brush away any hairs from the cutters.
6.
For a more thorough cleaning, lift out the three cutters (Fig. D).
7.
Wash the shaving head unter running water (Fig. E). Allow to dry thoroughly.
8.
Carefully refit the three cutters.
9.
Refit the retainer. Locate the centre arrow and slide the retainer in the same
direction as the arrow until it clicks into place (Fig. F).
10. Once the shaver head is assembled, align the spring hinge with the slot at the back
of the hair pocket and press into place (Fig. G). Finally, close the head assembly.
TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.
6
Advertisement
Table of Contents
