Replacing The Datatrak Battery - Graco EcoQuip 300 Operation, Repair, And Parts

Repair
Replacing the the DataTrak DataTrak Battery
Replacing Replacing the DataTrak
FIRE AND AND EXPLOSION EXPLOSION HAZARD
FIRE FIRE AND EXPLOSION
To reduce the risk of fire and explosion, the battery
must be replaced in a non-hazardous location.
Use only an approved replacement battery (see
table). Use of an unapproved battery will void
Graco's warranty.
Replace Battery Battery
Replace Replace Battery
1. Unscrew cable from the back of the reed switch
assembly.
2. Remove the cable from the two cable clips.
32
Battery
Battery
HAZARD
HAZARD
3. Remove the DataTrak module from the bracket.
Take the module and attached cable to a
non-hazardous location.
4. Remove the two screws on the back of the
module to access the battery.
5. Disconnect the used battery and replace it with
an approved battery.
Approved Approved Batteries Approved
Energizer alkaline #522
Varta alkaline #4922
Ultralife lithium #U9VL
Duracell alkaline #MN1604
Batteries Batteries
334143C