Removing A Jammed Laminating Pouch; Cleaning - ALDI OL 250-L-17 User Manual

Cleaning

The heating rollers will automatically pull the laminating pouch in and move it
to the laminating pouch output slot
force to pull out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
− If necessary, you can cut off excessive material after it has cooled
− Repeat the process if the laminating pouch has not adequately
5. Move the ON / OFF switch to "OFF" ( ) to switch the laminator off.

Removing a jammed laminating pouch

The laminator is equipped with an antiblocking system. If the laminating pouch was
not inserted straight or it becomes jammed in the laminator, proceed as follows:
1. Move the ABS switch
it down (see Fig. B).
2. Pull the laminating pouch
It is recommended you pull the laminating pouch out in the direction
of its larger end.
You can place the document in a new laminating pouch and laminate it again.
Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation. You may burn
yourself.
− Always let the laminator cool off completely before you clean it.
NOTICE!
Risk of short circuit!
Water or other liquids that have penetrated the housing may cause
a short circuit.
− Never submerge the laminator in water or other liquids.
14
off.
adhered to the document.
4
towards the laminating pouch infeed slot
6
out of the laminator.
on the front of the laminator. Do not use
5
2
and hold