Kenmore Elite 795.5182 Use & Care Manual page 13

Reinstalling the right (refrigerator) door
(1)
(2)
Type 1
1. Place the door onto the lower hinge pin.
2. Fit top hinge (4) over hinge lever latch (5) into place.
Rotate lever (3) counterclockwise to secure hinge.
NOTE: Regardless of the hinge lever type, the
reinstallation process is the same.
3. Hook the tab on the switch side of the corner under
the edge of the wire opening in the cabinet top.
Position the cover (2) into place. Insert and tighten
the cover screw (1).
Reinstalling the right (refrigerator) door
(2)
(1)
(4)
(5)
(6)
(7)
Type 1
1. Feed the water tubes through the lower hinge pin and
place the door onto the lower hinge pin.
2. Fit top hinge (6) over hinge lever latch (7) and into
place. Rotate lever (5) clockwise to secure hinge.
NOTE: Regardless of hinge lever type, reinstallation
process is the same.
3. Install the grounding screw (4) and connect all the
wire harnesses (3).
4. Hook tab on door switch side of cover (2) under
edge of wire opening in cabinet top. Position cover
into place. Insert and tighten cover screw (1).
(3)
(3)
(4)
(5)
(4)
(5)
Type 2
(3)
(7)
(5)
(6)
Rivet
Type 2
5. Reconnect the water tubes by inserting the tubes into
the connectors.
Insert Line
Rivet
13
REFRIGERATOR INSTALLATION
Collet
Tube