Connecting The Connection Cord - Samsung Duct Type Series User & Installation Manual

Connecting the connection cord

the electric connections.
The indoor unit is powered by the outdoor unit by means of a H07 RN-F connection cable (or a more power model),
with insulation in synthetic rubber and jacket in polychloroprene(neoprene), in accordance with the requirements of standard EN 60335-2-40.
1. Remove the screw on the electrical component box and remove the cover plate.
2. Route the connection cord through the side of the indoor unit and connect the cable to terminals; refer to the figure below.
3. Route the other end of the cable to the outdoor unit through the ceiling & the hole on the wall.
4. Reassemble the electrical component box cover, carefully tightening the screw.
Wiring diagram
1 phase
Indoor Unit
1(L) 2(N) 1 2 F1 F2
L1 L2
1(L) 2(N) L
N
L1 L2 L1 L2
Cable tie
Indoor Power
Main power cable Cable clamp
Outdoor Unit
Between Indoor and Outdoor Connection cable Specifications(Common in use)
Indoor Power supply
Power Supply
±10%
Power supply cords of parts of appliances for outdoor use shall not be lighter than polychloroprene sheathed flexible cord.
Terminal Block SPEC (Indoor)
8.4 9.5
Tightening Torque (kgf·cm)
M4
V1 V2 F3 F4
Communication cable
Indoor Power cable
1.5mm² ,3wires
9.5
8.4
Communication Cable
In case of extending the electric wire, please
DO NOT use a round-shaped pressing socket.
WARNING
- Incomplete wire connections can cause
electric shock or a fire.
31