Cisco 897VAW Installation Manual page 4

Chapter 1 Product Overview
1. 1.ADSL and VDSL (up to 17a) single-pair functionality uses the center pair of pins in the RJ-11 connector. VDSL 30a single
pair functionality makes use of the pins just adjacent to the center pins. VDSL Bonding makes use of both the center pair pins
& those just adjacent to the center pair to provide the 2 bonded VDSL lines. For more information, see
Integrated Services Routers Data Sheet.
2. 2.Ports 0 through 3 can be configured as POE, which is an optional feature for this model. If this feature is not configured
with the factory order, you must order and install it to enable the PoE function.
Caution
Figure 1-72
Figure 1-72
Table 1-39
Table 1-39
Number LED
1
2
The primary WAN port is designed for an RJ-11 or RJ-14 connector only. Damage to the
primary WAN port may occur if a non-RJ-11 or RJ-14 connector is inserted.
shows the front panel of the Cisco 897VAB-K9 ISR.
Front panel of the Cisco 897 VAB-K9 ISR
2 4
1 3
ISDN
CD0 CD1 B1 B2
6 8
7 9
describes the LEDs for the Cisco 897VAB-K9 ISR.
LED Descriptions for the Cisco 897VAB-K9 ISR
Color
Power OK Green
PoE OK Green/Yellow
5
Description
On—DC power is being supplied to the router and the
Cisco IOS software is running.
Blinking—Boot up is in process, or the router is in ROM
Monitor (ROMMON) mode.
Off—Power is not supplied to the router.
Off—Both POE card & POE power supply are not
present.
Yellow On—Either POE card or POE power supply is
not present.
Green On—Both POE card & POE power supply are
present.
Cisco Integrated Services Router Hardware Installation Guide
Cisco 860, 880, 890 Series
Cisco 890 Series
1-111