DIR-615 Wireless N300 Router
User Manual
Remote Access to Device
On the Advanced / Remote access to device page, you can configure access to the web-based
interface of the router. By default, the access from external networks to the router is closed. If you
need to allow access to the router from the external network, create relevant rules.
To create a new rule, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter
IP address
Mask
Public port
Protocol
After specifying the needed parameters, click the Apply button.
To edit a rule for remote access, select a needed field in the relevant line of the table, change its
value, and click the Apply button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the Delete button. Then click the Apply button.
Figure 141. The Advanced / Remote access to device page.
A host or a subnet to which the rule is applied.
The mask of the subnet.
An external port of the router.
The protocol available for remote management of the router.
Description
Page 178 of 208
Configuring via Web-based Interface