Security Setup - Kenwood DNX8160DABS Instruction Manual

Setting Up

Security Setup

You can set up a security code to protect
your receiver system against theft.
1
Press the
volume knob.
Popup menu appears.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [Security].
Security screen appears.
4
Set each item as follows.
SI *
1
A red indicator will blink on the unit after the ACC
is set to OFF, warning potential thieves. If turned
to "ON" (default), the security indicator on the
front panel flashes when the vehicle ignition is off.
Security Code Set
Register the security code for the unit.
Security Code Cancellation
Clear the security code.
Security Code Change
Change the security code.
*1 Except DNX716WDABS
82 82
<MENU> button/
Security Code
When the Security Code function is
activated, the code cannot be changed
and the function cannot be released. Note
the Security Code can be set as 4 to 8-digit
number of your choice.
1
Touch [Security Code Set] on the
Security screen.
Security Code Set screen appears.
2
Enter a security code with 4 to 8-digit
number and touch [Enter].
3
Enter the same code again and touch
[Enter].
Now, your security code is registered.
NOTE
• Touch [BS] to delete the last entry.
• If you enter a different security code, the screen
returns to step 2 (for the first code entry).
• if you have disconnected the Receiver from
battery, enter the correct security code as that
you have entered in step 2 and touch [Enter]. You
can use your receiver.
To change the security code:
1
Touch [Security Code Change] on the
Security screen, then repeat step 2 and
3.
To clear the security code:
1
Touch [Security Code Cancellation] on
the Security screen.