Philips PD7010 Service Manual
Hide thumbs
Also See for PD7010:
- User manual (22 pages) ,
- Quick start manual (2 pages) ,
- User manual (18 pages)
Advertisement
Quick Links
DVD Portable
Service Manual
TABLE OF CONTENTS
Technical Specification, PCBs Location....................... 1
Safety Instruction ...................................................... 2
Instruction for Use...................................................... 3
Mechanical and Dismantling Instructions...................... 4
Service Modes, Troubleshooting.................................. 5
Overall Block Diagram, Wiring Diagram......................... 6
Electrical Diagram...................................................... 7
Exploded View Diagram & Service Part List....................8
Revision List............................................................. 9
Copyright 2009 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or
transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise
without the prior permission of Philips.
Published by BL AVM
Version
2.0
Printed in the Netherlands
PD7010/12/93/77/78
Chapter
3141 785 34830
Subject to modification
Advertisement
Related Manuals for Philips PD7010
Summary of Contents for Philips PD7010
- Page 1 Exploded View Diagram & Service Part List………………..8 Revision List……………………………………………………. 9 Copyright 2009 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise without the prior permission of Philips.
- Page 2 1.0 TECHNICAL SPECIFICATION VIDEO/ AUDIO Characteristic Testing discs Test discs DOLBY: Dolby Test disc ABEX: TDV-540A VIDEO FORMAT DVD / SVCD / JPEG / MPEG4 / DIVX3, 4,5,6(Home theater) AUDIO FORMAT CD / MP3(32 - 320 kbps) Video (PAL / NTSC) White bar : 714mV +10%/-20% Sync.
- Page 3 1.1 PCBs Location VERSION VARIATIONS Type/Versions: PD7010 Service policy Board in used: MAIN BOARD KEY BOARD TFT BOARD *TIPS: C -- Component Lever Repair. M -- Module Lever Repair X -- OCX...
- Page 4 5. Refer below table for your region code setting Procedure for SW upgrade 1. The upgrade will provide a document re-named: PHILIPS.BIN 2. “PHILIPS.BIN” copy to CD-ROM into the data; 3. Reading the CD-ROM in accordance with prompt press ”OK” key to upgrade...
- Page 5 2.0 SAFTETY INSTRUCTIONS WAARSCHUWING WARNING Alle IC’s en vele andere halfgeleiders zijn All ICs and many other semi-conductors are gevoelig voor electrostatische ontladingen susceptible to electrostatic discharges (ESD). (ESD). Careless handling during repair can reduce life Onzorgvuldig behandelen tijdens reparatie kan drastically.
- Page 6 2.1 ESD PROTECTION When the power supply is being turned on, you may not remove this laser cautions label. If it removes, radiation of laser may be received. PREPARATION OF SERVICING Pickup Head consists of a laser diode that is very susceptible to external static electrocity. Although it operates properly after replacement, if it was subject to electrostatic discharge during replacement, its life might be shortened.
- Page 7 SAFTY NOTICE SAFTY PRECAUTIONS LEAKAGE CURRENT CHECK Plug the AC line cord directly into a 120V AC outlet (do Measure the AC voltage across the 1500 resistor. not use an isolation transformer for this check). Use an The test must be conducted with the AC switch on and AC voltmeter, having 5000 per volt or more sensitivity.
- Page 8 2.2 SAFETY INSTRUCTIONS Battery Handling Guideline Since the battery is packed in soft package, to ensure its better performance, it’s very important to carefully handle the battery 2.2.1 Soft Aluminium foil The soft aluminum packing foil is very easily damaged by sharp edge parts such as Ni-tabs, pins and needles. Don’t strike battery with any sharp edge parts Trim your nail or wear glove before taking battery Clean worktable to make sure no any sharp particle...
- Page 9 3.0 Instruction for Use You can download this information from the following websites: http://www.philips.com/support http://www.p4c.philips.com...
- Page 10 4.0 MECHANICAL AND DISMANTLING INSTRUCTIONS Remove screws on back cabinet to separate top cabinet and back cabinet. Generally open the middle cabinet. Remove screws on main board. Disassemble hous and connecter. Remove screws on KEY board. Disassemble hous and connecter. Remove screws on front cabinet.
- Page 11 Trouble shooting chart Spindle motor does not move Motor not move Check the FFC connection Correct connection between 24P and the loader. Check whether “M+5V” Check the P+5V power (VCC) voltage is normal. supply Check whether laser voltage Check/Replace Q9 Q10. (1.9V for CD &...
- Page 12 Trouble shooting chart The power can not be on or off main board can’t start-up Check the power supply from replace adapter adapter Check/replace D8,Q1,Q2,Q3,R2 Check if the DC_IN from D4 is ok Whether the DVCC3 is ok check/replace Q5,L12,U2,D5 Whether the U6 and peripheral component is Replace U6.and peripheral component normal,the program in u6 is normal...
- Page 13 Trouble shooting chart Disc cannot be read . Disc cannot be read. Check the FFC connection Check the loaded circuit between 24P and the loader. Check whether there is Check whether peripheral laser voltage (1.9V for CD components are eroded or defect and 2.3V for DVD) on Collector of Q9 &Q10 Check...
- Page 14 Trouble shooting chart Only DVD disc or only disc except DVD can be played Only DVD disc, or only disc except DVD can be Played. Check Check the loaded circuit connection between 24pin and the loader. Check laser voltage (1.9V) Check the solder status on U5 and output on Collector of Q9 peripheral components...
- Page 15 Trouble shooting chart Distorted audio and loud noise Distorted audio and loud noise Check he power supply voltages +9V Replace L11 to the operation amplifying L11 are normal Check whether check/Replace the peripheral component peripheral component of U11 and U12 Checking the U11 leads the feet has no to break Correct connection...
- Page 16 Trouble shooting chart Abnormal color of video picture Abnormal color of video picture Check whether the 27MHz Check xt1, R32, C30 and C31 output signal is normal. Check whether the 3.3V Check other of power supply electric and 1.8V power supply circuit voltages on the decoder board are normal.
- Page 17 Trouble shooting chart No video picture, no sound. No video picture, no sound. Check whether voltages from the power Check the loaded circuit board to the decoder board are normal. CVBS(L27 point) waveform Check if the reset circuit consisting of EC42,L22,L21,C88,C89,C90,R75 is normal Change EC42,L22,L21 (at a high level for tens of milliseconds, then constantly at 0V).
- Page 18 Trouble shooting chart No display on LED, and buttons do not work buttons do not work Check whether there is correct contact Correct connection J 5 of decoder board Check DV33(+3.3V) Fix power supply board top voltage on the power a power supply for should and KEY board electric circuit...
- Page 25 TO HANSTAR PANNEL...
- Page 34 8. 1 SERVICE PART LIST Service Pos. Service Description Photo 12NC 996510032058 DVD DOOR PC BLACK PD7010/12 996510021997 LENS ABS PET741D PD7010/12 996510032067 BOTTOM-HOUSING WHITE PD7010/12 996510032069 POWER KNOB ABS WHITE PD7010/12 996510032066 TOP-FRAME ABS WHITE PD7010/12 996510032057 DISPLAY-FRAME ABS...
- Page 35 PD7010/12 996510031334 KEY-SELECT ABS PET741B PD7010/12 996510031235 SW ADP 9V/0.8A VDE 4.0 BLACK ADAPTOR PD7010/12 996510021031 CAR CORD PET741 CARADAPTOR PD7010/12 996510032055 GAME CD-R DISC GAMEDISC PD7010/12 996510032078 GAME HANDGRIP ASSY GAMEPAD PD7010/12 996510031499 TRAVEL BAG FOR PHILIPS MOUNTINGBAG PD7010/12...
- Page 36 9.0 REVISION LIST Version 1.0 Initial release Version 2.0 Add version /93/77...