Replacing The Filter - FilterStream AirTamer A600 Instruction Manual

Replacing the Filter

Please follow these steps to replace your AirTamer®
AIR FILTER.
1. Turn the AirTamer® off by pressing the
POWER BUTTON and unplugging the unit
from the electrical outlet.
2. Remove the
on the AIR EXIT GRILL TABS (2a) and pulling
the AIR EXIT GRILL (2b) away from the unit.
3. Remove the
the sides of the AIR FILTER and pulling the
AIR FILTER out of the unit.
4. Mark the suggested month of
replacement on the new AIR FILTER by
checking off the appropriate month (e.g. If it
is suggested that the AIR FILTER be replaced
in 6 months and you install the AIR FILTER
on January 1st, put a check in the box beside
the letter representing the month to replace
– in this case July).
5. Insert the new
bottom of the AIR FILTER inside your
AirTamer® and pushing it past the large front
rubber tab. Then push the top of the AIR
FILTER past the large front rubber tab at the top
of the unit.
NOTE:
make sure ThaT The air floW
arroWs face ToWards The froNT
of The uNiT.
6. Replace the
7. Press and hold down the
seconds to reset the CHANGE FILTER memory.
makes life better!
AIR EXIT GRILL by pushing down
AIR FILTER by firmly gripping
AIR FILTER by placing the
AIR EXIT GRILL.
CHANGE FILTER LIGHT BUTTON for three (3)
AIR FILTER
2a
2b
3
5
6
7
Page 13