Fetco CBS-51H10 User Manual page 21

LUXUS Server Problem
LUXUS leaking from the base
LUXUS leaking from sight gauge
Coffee not hot enough
Drip from faucet
Coffee won't dispense
Possible Cause
Overflow of coffee, or water from
cleaning running down the side and
collecting in the black plastic base
(1.5 gallon LUXUS only)
Bad O-ring gasket behind faucet
shank
(1.5 & 3 gallon LUXUS)
Brew level set too high
Sight gauge cap not tight
Lower gasket missing or bad
LUXUS not preheated before first
brew of the day
Attempting to hold coffee too long.
Using 1/2 batch on regular basis
Judging temperature from a sample
that is too small, taken from an
infrequently used LUXUS
Blockage in faucet
(hair from cleaning brush, coffee
oils, etc.)
Faucet seat cup
Vents closed on top of gauge tube
and or twist lock cover
21
Solution
-Remove the plastic base (it slips on and off) wipe the
interior and plastic base dry and reassemble. Monitor brew
practices & do not clean containers in sinks or dishwashers
-Remove the faucet, then unbolt the faucet shank from the
LUXUS and replace the O-ring.
-Adjust timers for proper level
-Tighten gauge cap (show operators how this could have
been loosened when the vent cap was opened)
-Replace and or discourage casual cleaning practices
-Preheat the LUXUS 1/2 full with hot water and let stand for
15 minutes
-Review discard times
-Encourage full batch use except at end of day or shift.
Explore the need for smaller brewers
-A small amount of coffee in the faucet body will cool in
about 15 minutes.
-Remove faucet bonnet (top part with handle attached) and
clean seat cup and faucet body. Clean on regular basis
-Remove faucet bonnet (top part with handle attached) and
replace seat cup. Stained cups are OK cracked or brittle
are not.
-Open vents (vents are closed only for transporting the
servers or to extend holding times prior to serving coffee)