Table of Contents
Advertisement
4) Press key "Read"，select burning file (for example MERGE.bin) as Fig. 4.
5) Select menu "Auto", then select items "All chip", "program" and other configuration as Fig. 5
6) Press key "Run" as Fig. 4 to begin burning software, there are two steps for the process: Erase
and Program
normal burning steps are as follows:
the first step "Erasing...， Flash Status: 03" will be lasting for a moment, otherwise skipping over
means unsuccessful erasing; please confirm process （2） and then burn software again;
the following step "Programming...，Flash Status:00" will be done until a prompt "Pass" is
displayed.
Fig. 4 Burning file
Fig. 5 Burning Configuration
Advertisement
Table of Contents
