Replacing An Ink Tank - Canon PIXMA iP4200 Quick Start Manual

Replacing an Ink Tank

When the printer runs out of ink, replace the empty ink tank with a new one. Specify the following ink tanks
when purchasing.
Black : CLI-8BK
Yellow : CLI-8Y
If the Top Cover is opened more than ten minutes, the Print Head Holder moves to the right side. If this
occurs, close the Top Cover, and open it again.
Print Head Lock Lever
20
Black : PGI-5BK
Magenta : CLI-8M
1
Open the Top Cover.
2
Open the Paper Output Tray and pull
down the Inner Cover, then remove the
empty ink tank.
Do not touch the Print Head Lock Lever.
3
Install the new ink tank. Press the
mark on the ink tank until it clicks into
place and then its red lamp lights.
Ensure that all the ink tanks are installed in the order
directed by the label. The printer cannot be used
unless all ink tanks are installed.
4
Put back the Inner Cover and close the
Top Cover when finished.
The ALARM lamp flashes orange if an ink tank is
not installed properly. Open the Top Cover and
make sure that all the ink tanks are installed in the
correct order directed on the label.
Cyan : CLI-8C