Table of Contents
Advertisement
Wheels
RIGHT
REAR
(9)
(7) lug
(8) slot
(9) brake panel
98
Servicing Your Honda
Installation
1.
Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
slot ( ) in the brake panel ( ). Check that
8
the chain adjusters are installed properly.
2.
Adjust the drive chain (page
(7)
3.
Torque the axle nut to:
80 lbf·ft (108 N·m , 11.0 kgf·m)
4.
Adjust the rear brake (page
5.
Apply the rear brake, release it, then spin the
(8)
wheel and check that it rotates freely. Repeat
this procedure several times.
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
7
9
89
107
).
).
Hide quick links:
Advertisement
Table of Contents
