Advertisement
far end, so you drive the model toward and past your position. In
addition to maximizing the radio's range, this technique will keep
your model closer to you, making it easier to see and control.
No matter how fast or far you drive your model, always leave
adequate space between you, the model, and others. Never drive
directly toward yourself or others.
TQ 2.4GHz Binding Instructions
For proper operation, the transmitter and receiver must be
electronically 'bound.' This has been done for you at the factory.
Should you ever need to re-bind the system or bind to an additional
transmitter or receiver, follow these instructions. Note: the receiver
must be connected to a 4.8-6.0v (nominal) power source for binding
and the transmitter and receiver must be within 5 feet of each other.
1. Press and hold the SET button on the transmitter.
2. Turn on the transmitter and release the SET button. The status
LED will flash red slowly, indicating that the transmitter is in
bind mode.
3. Press and hold the LINK button on the receiver.
4. Turn on the vehicle and release the LINK button. The LED on the
receiver will flash red, indicating that the receiver is in bind mode.
5. When the LEDs on both the transmitter and the receiver turn solid
green, the system is bound and ready for use. Confirm that the
steering and throttle operate properly before driving your model.
TRAXXAS TQ 2.4GHz RADIO SYSTEM
TRANSMITTER LED CODES
LED Color / Pattern
Name
Solid green
Normal Driving
Mode
Slow red
Binding
(0.5 sec on / 0.5 sec off)
Flashing medium red
Low Battery
(0.25 sec on / 0.25 sec off)
Alarm
Flashing fast red
Link Failure /
(0.125 sec on / 0.125 sec off)
Error
RECEIVER LED CODES
LED Color / Pattern
Name
Solid green
Normal Driving
Mode
Slow red
Binding
(0.5 sec on / 0.5 sec off)
Flashing fast red
Fail-Safe / Low-
(0.125 sec on / 0.125 sec off)
Voltage Detect
Notes
See page 11 for information
on how to use the transmitter
controls.
See this page for more information
on binding.
Put new batteries in the
transmitter. See page 10 for
more information.
Transmitter and receiver are no
longer bound. Turn the system
off and then back on to resume
normal operation. Find source of
the link failure (i.e., out of range,
low batteries, damaged antenna).
Notes
See page 11 for information
on how to use your transmitter
controls.
See this page for more information
on binding.
Consistent low voltage in the
receiver triggers Fail-Safe so
that there is enough power to
center the throttle servo before it
completely loses power.
Fail-Safe
Your Traxxas radio system
is equipped with a built-
in Fail-Safe function that
returns the throttle to its
last saved neutral position
in the event of a signal loss.
The LED on the transmitter
and on the receiver will
rapidly flash red when the
Fail-Safe mode is activated. If
Fail-Safe activates while you
are operating your model,
determine the reason for
signal loss and resolve the
problem before operating
your model again.
T-MAXX • 13
Advertisement
