Mercedes-Benz 500 SEC Operator's Manual page 56

Combination Switch
1 Low beam (exterior lamp
switch position
2 High beam (exterior lamp
switch position
3 High beam flasher (high beam
available independent of
exterior lamp switch position)
4 Turn signals, right
5 Turn signals, left
To signal minor directional changes,
such as changing lanes on a highway,
move combination switch to the point
of resistance only and hold it there.
)
To operate the turn signals
)
continuously, move the combination
switch past the point of resistance (up
or down). The switch is automatically
canceled when the steering wheel is
turned to a large enough degree.
6 Press switch briefly:
One wipe without washer water
(select only if window is wet)Press
switch past resistance point:
Windshield washer, windshield
wiper; headlamp cleaning system
(only in exterior lamp switch
positions or Canada only:
also in position when the engine is
running)
7 Windshield wiper
0 Wiper off
I Intermittent wiping
II Normal wiper speed
III Fast wiper speed
When coming to a stop or driving
slower than approx. 20 km/h (13
mph), the wiper speed automatically
switches to the next lower setting.
In setting "I", the interval between
wipes is lengthened.
Upon accelerating again, the wiper
speed returns to the previous setting.
Note:
The windshield washer reservoir,
hoses and nozzles are automatically
heated.
56