VTech CS6719 User Manual page 32

I cannot dial Make sure there is a dial
out. tone before dialing. It is
normal if the handset
takes a second or two
to synchronize with the
telephone base before
producing a dial tone. Wait
an extra second before
dialing.
Eliminate any background
noise. Mute the handset
before dialing, or dial
from another room in
your home with less
background noise.
The display The handset is
shows To deregistered from the
telephone base.
register HS...
and ...see
Place the handset in the
manual
telephone base to register
alternately.
it back. The handset
The handset
shows Registered and
does not work
you hear a beep when
at all.
the registration process
completes. This process
takes about 90 seconds to
complete.
The display Place the handset in the
shows Low
telephone base or charger
battery. for charging.
The battery Make sure the handset is
does not placed in the telephone
charge in the base or charger correctly.
handset or
If the battery is completely
the handset
depleted, charge the
battery does
battery for at least 30
not accept
minutes before use.
charge.
You may need to purchase
a new battery.
The telephone Make sure the ringer
does not ring volume is not set to off.
when there is
The handset may be too
an incoming
far from the telephone
call.
base. Move it closer to the
telephone base.
My handset
beeps
and is not
performing
normally.
I hear other
calls when
using the
telephone.
I hear noise
on the
cordless
handset and
the keys do
not work.
26
Move the handset closer
to the telephone base. It
may be out of range.
Disconnect the telephone
base from the telephone
wall jack. Plug in a
different telephone. If you
still hear other calls, the
problem is probably in
the wiring or telephone
service. Contact your
telephone service
provider.
Make sure the telephone
line cord is plugged in
securely.