Table of Contents
Advertisement
Indicator
Function
Duration of the timer end signal
™‡
‚
10 seconds.*
30 seconds
ƒ n
1 minute.
„
Activation of the filament circuits
™ˆ
Switched off.
‹
Switched on.
‚
Last setting before the hotplate was switched off.*
ƒ
™‹
Reset to basic setting
Switched off.
‹
‚
Switched on.
*Basic setting
Changing the basic settings
The hob must be switched off.
Switch on the hob.
1.
Within the next 10°seconds, touch the
2.
4 seconds.
™
and
‚
flash alternately in the left-hand display;
the right-hand display.
Cleaning and care
The information in this section provides help on how best to
care for your hob.
Suitable maintenance and cleaning products can be purchased
from the after-sales service or in our e-Shop.
Ceramic
Clean the hob after each use. This will prevent spills from
burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for ceramic. Follow
the cleaning instructions on the packaging.
Never use:
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain remover
■
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
■
Ground-in dirt can be best removed with a glass scraper,
available from retailers. Please note the manufacturer's
instructions.
10
0
symbol for
‹
lights up in
Touch the
symbol repeatedly until the desired symbol
0
3.
appears on the left-hand display.
Use the setting disc to set the desired value.
4.
Touch the
symbol for 4 seconds.
0
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
You can also obtain a suitable glass scraper from our after-
sales service or from the e-Shop.
Cleaning the control panel
Use only warm, soapy water. Do not use harsh or abrasive
agents. The glass scraper should not be used for this purpose.
The control panel could be damaged.
Lemon and vinegar are not suitable for cleaning the control
panel. They could create dull areas.
Setting discs
It is best to clean the setting discs with lukewarm soapy water
only. Do not use harsh or abrasive agents. Do not clean the
setting discs in the dishwasher.
Advertisement
Table of Contents
