Mitsubishi HC6500 User Manual page 27

Menu operation (continued)
2. INSTALLATION menu
opt.
INSTALLATION
KEYSTONE
LAMP MODE
AUTO POWER
ON
AUTO POWER
OFF
SPLASH
ON
SCREEN
BACK COLOR
IMAGE
REVERSE
TRIGGER OUT
TEST PATTERN
LENS LOCK
2. INSTALLATION menu
ITEM
KEYSTONE
LAMP MODE
AUTO POWER ON
AUTO POWER OFF OFF / 5 - 60min
SPLASH SCREEN
BACK COLOR
IMAGE REVERSE
TRIGGER OUT
TEST PATTERN CROSS HATCH
LENS LOCK
• When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW about one minute
after turn-on.
• When the lamp mode is switched, the projected image may fl icker. This is not a product malfunction.
• Do not change the setting of LAMP MODE frequently.
• To cancel the test pattern, press any button.
Downloaded from www.Manualslib.com
A V MEMO R Y 1
0
STANDARD
OFF
OFF
ON
BLUE
OFF
OFF
CROSS HATCH
OK
SETTING FUNCTION
±15 Use to correct vertical keystone distortion.
STANDARD Select this option when you want to view images in a well-lit room.
LOW Select to moderate the intensity of the lamp. The fan operating sound is
reduced and the lamp lifetime becomes longer.
ON / OFF When ON is chosen, the lamp is automatically lit when the power cord is
plugged in the wall outlet. Choose ON when using the projector mounted on
the ceiling.
• The projector is in the stand-by mode when the lamp is off. Use the remote
control to turn on the lamp.
Use to set the time elapsed before the projector enters the stand-by mode
when there is no signal input from the source.
ON / OFF Choose ON to display the splash screen when the power is turned on.
BLUE / BLACK Use to change the color of the screen that appears when no signal is supplied.
OFF Select when viewing images from the front with the projector installed on the
fl oor.
MIRROR Select when viewing images projected from the behind of the screen with the
projector installed on the fl oor.
INVERT Select when viewing images projected from the behind of the screen with the
projector installed on the ceiling.
MIRROR INVERT Select when viewing images from the front with the projector installed on the
ceiling.
SCREEN The trigger output signal (12 V) is output from the TRIGGER terminal when the
lamp illuminates.
ANAMORPHIC
The trigger output signal (12 V) is output from the TRIGGER terminal when the
aspect ratio is set to ANAMORPHIC 1 or ANAMORPHIC 2.
OFF
The trigger output signal (12V) isn't output.
Select to show the test cross hatch pattern.
WHITE
Select to show the maximum brightness image.
BLACK Select to show the minimum brightness image.
ZOOM/FOCUS LOCK Use to enable or cancel the FOCUS LOCK and ZOOM LOCK.
LENS SHIFT LOCK Use to enable or cancel the LENS SHIFT LOCK.
LENS SHIFT RESET Use to reset the position of the lens to the factory setting.
manuals search engine
EN-27