Char-Broil 463234711 Product Manual
  1. Manuals
  2. Brands
  3. Char-Broil Manuals
  4. Grill
  5. 463234711
  6. Product manual

Char-Broil 463234711 Product Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

The following are trademarks registered by W.C. Bradley Co. in the U.S. Patent and Trademark Office: Caldera®; Charcoal2Go®; Char-Broil®; American Gourmet®;
Bandera®; Brush Hawg®; CB 940®; Char-Diamonds®; Char-Broil Charcoal/Gas®; Everybody Grills®; Grill 2 Go®; Grill 2 Go® Express®; Grill Lovers®; Infrared
Grilling That's All About U®; Keepers of the Flame®; Magneto®; New Braunfels Smoker Company®; Patio Bistro®; Patio Caddie®; Patio Kitchen®; Pro-Sear®;
RED®; Quantum®; Santa Fe®; Sear and Grill®; Sierra®; Signature Series®; Sure2Burn®; The Big Easy®; U®; Wild West Tradition®; and the following marks:
The following are trademarks of W.C. Bradley Co.:America's Legendary Barbeque Company™; Advantage Series™; Auto-Clean™;Chef Tested™; Commercial
Series™; Designer Series™;; Diamond Flame™; Double Chef™; Everybody Outside™; FastStart™; FlavorMaster™; Front Avenue™; Grill 2 Go® Advantage™;
Grill 2 Go® Ice™; Hog and Yard Bird™; H20 Smoker™; Infrared. Grilling's Juicy Little Secret™; Incredible Taste. Infallible Results™; Infrared Inside™; Let's Grill
Something Together™; Longhorn™;; Precision Flame™; Quick2Burn™; QuickSet™; Ready When You Are™; Season, Set, And Savor™; Sizzle On The Grill™;
SureFire™; Torchfork™; Trentino™; Universal Grill Parts™; You Bring the Party™
© 2010 Char-Broil, LLC Columbus, GA 31902
PRODUCT GUIDE
MODEL 463234711
IMPORTANT: Fill out the product record information below.
Serial Number
Date Purchased
For support and to register your
grill, please visit us at
www.charbroil.com
If you have questions or need
assistance during assembly,
please call 1-800-241-7548.
®
TEC™ is a trademark of Tec Infrared Grills.
Printed in China
See rating label on grill for serial number.
Estimated assembly time: 35-40 minutes
®
Assembly instructions © 2010
12/14/10 • G651-001-080801

Advertisement

Table of Contents
loading

Related Manuals for Char-Broil 463234711

Summary of Contents for Char-Broil 463234711

  • Page 1 Estimated assembly time: 35-40 minutes The following are trademarks registered by W.C. Bradley Co. in the U.S. Patent and Trademark Office: Caldera®; Charcoal2Go®; Char-Broil®; American Gourmet®; Bandera®; Brush Hawg®; CB 940®; Char-Diamonds®; Char-Broil Charcoal/Gas®; Everybody Grills®; Grill 2 Go®; Grill 2 Go® Express®; Grill Lovers®; Infrared Grilling That’s All About U®;...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS DANGER For Your Safety ........2-3 If you smell gas: Grilling Guide.
  • Page 3 WARNING CAUTION CALIFORNIA PROPOSITION 65 Using pots larger than 6 quarts in capacity could exceed weight limit of the 1. Combustion by-products produced when using this product contain chemicals known to the State of side burner shelf California to cause cancer, birth defects, and other or side shelf, reproductive harm.

  • Page 4: Grilling Guide

    GRILLING GUIDE – Getting Started Temperature The temperature gauge in the hood of your new grill measures air temperature. The air temperature inside your grill will never First Time Use be as hot as the temperature at the cooking surface. Read your Assembly Manual and ensure the grill is put together properly.
  • Page 5 Rotisserie Cooking GRILLING GUIDE – Grilling 101 Rotisserie cooking is best for 'round' meat, such as large roasts, whole poultry, and pork. It generally requires an accessory motor Outdoor grilling is really quite simple. You'll succeed with and spit rod that allows the meat to be turned at a constant burgers, dogs, or steaks usually on your very first try.
  • Page 6 Wood Chips GRILLING GUIDE – Tips & Tricks For extra smoke flavor when grilling, try adding wood chips. Cooking on your new grill is a hands-on experience, and it is Soak the chips in water for approximately 30 minutes before recommended to remain outside with your grill while cooking.
  • Page 7 Cooking surfaces: If a bristle brush is used to clean any of the GRILLING GUIDE – Cleaning Your Grill grill cooking surfaces, ensure no loose bristles remain on cooking Why Clean? surfaces prior to grilling. It is not recommended to clean cooking surfaces while grill is hot.

  • Page 8: Use And Care

    LP Cylinder USE AND CARE •The LP cylinder used with your grill must meet the following requirements: DANGER •Use LP cylinders only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. •...
  • Page 9 LP Cylinder Exchange Connecting Regulator to the LP Cylinder •Many retailers that sell grills offer you the option of replacing 1.LP cylinder must be properly secured onto grill. (Refer to your empty LP cylinder through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2.Turn all control knobs to the OFF position.
  • Page 10 Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP cylinder. 3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately.
  • Page 11 Safety Tips WARNING Before opening LP cylinder valve, check the coupling nut for tightness. When grill is not in use, turn off all control knobs and LP cylinder valve. For Safe Use of Your Grill and to Avoid Serious Never move grill while in operation or still hot. Injury: Use long-handled barbecue utensils and oven mitts to avoid •...
  • Page 12 Ignitor Lighting (continued) Burner Flame Check 8. For grills equipped with ELECTRONIC IGNITION at • Remove cooking grates and flame tamers. Light burners, rotate each burner: knobs from HI to LOW. You should see a smaller flame in Repeat steps 4 through 6 to light each burner. LOW position than seen on HI.
  • Page 13 3. Remove carryover tubes and burners. CAUTION Detach electrode from burner. NOTE: Removal/Detachment method will depend on the SPIDER ALERT! burner configuration. See different configurations in illustrations below. 5. Carefully lift each burner up and away from valve openings. We suggest three ways to clean the burner tubes. Use the one SPIDER AND WEBS easiest for you.

  • Page 14: Limited Warranty

    LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*.

  • Page 15: Parts List

    PARTS LIST Qty Description Qty Description FIREBOX LEFT SIDE CART PANEL MAIN BURNER-TUBE BURNER BOTTOM SHELF MAIN BURNER-BAR BURNER FRONT DOOR BRACE ELECTRODE, F/ TUBE BURNER LEFT DOOR ELECTRODE, F/ BAR BURNER RIGHT DOOR CARRY OVER TUBE HANDLE, F/ DOOR CONTROL PANEL, MAIN LOWER BACK PANEL ELECTRONIC IGNITION MODULE...

  • Page 16: Parts Diagram

    PARTS DIAGRAM...

  • Page 17: Assembly

    ASSEMBLY • Place bottom shelf between side panels with cut out hole for LP cylinder on left . Attach to left and right side panels with (4) 1/4”-20x2-3/8” machine screws and 1/4”-20 flange nuts at front, and (2) 1/4”-20x2-3/8” machine screws and 1/4”-20 flange nuts at rear.
  • Page 18 • Hook tank exclusion wire onto the metal tabs on lower back panel, attach other ends to bottom shelf with #8x3/8” sheet metal screws. Lower Back Panel #8x3/8" Sheet Metal Screws Qty. 2 Metal Tab • Place front door brace as shown. Attach to left and right side panels with 1/4"-20x2-3/8"...
  • Page 19 • Turn assembly upside down. • Insert Caster Pin into the caster mounting plate to lock it in place, shown A. Spin the caster clockwise into the threads on the legs until secure. Remove the Caster Pin and repeat for remaining casters. Make sure the two locking casters are secured to the right legs and the non-locking casters are secured to the left legs.
  • Page 20 • This step requires two people to lift and position grill head onto cart. • Carefully lower the grill head onto the cart. Make sure the regulator hose is hanging outside the cart. Attach with 1/4”-20x1/2” screws. Right side panel removed for clarity Grill Head 1/4 -20x1/2"...
  • Page 21 • Attach towel bar to right side shelf with 1/4-20x1/2” Screws , 7mm lock washers and 7mm flat washers (A). • Hook side wall of shelf over support brackets on side of firebox (B). • Inside firebox attach right side shelf with (3) 7mm fiber washers and 1/4-20x1/2” screws, as shown (C). At back of firebox, attach the right side shelf with (1) 7mm fiber washer and 1/4-20x1/2”...
  • Page 22 • Hook side wall of sideburner shelf over support brackets on side of firebox (A). • Inside firebox attach sideburner shelf with (3) 7mm fiber washers and 1/4-20x1/2” screws, as shown (B). At back of firebox, attach the sideburner shelf with (1) 7mm fiber washer and 1/4-20x1/2” screw, as shown (A). •...
  • Page 23 • Attach sideburner bezel and valve with #8-32x3/8” SS screws. (A). • Place sideburner into shelf. Make sure valve is inside sideburner tube. Attach sideburner with #8-32 wing nut (B). Hook venturi clip to sideburner tube and around manifold. Attach sideburner ignitor wire (C). •...
  • Page 24 • Attach handle to door with #10-24x1/2” machine screws, 5mm flat washers and 5mm lock washers. • Insert hinge pin on bottom shelf into hole in door. Deress upper hinge pin in front door brace, align hinge hole on top of door, and release hinge pin into door.
  • Page 25 • Place heat tents over tube burners by inserting tabs into slots in front of firebox. Opposite ends of heat tents rest on pins in back of firebox. NOTE: There is no heat tent over bar burner. Heat Tent • Place cooking grates onto grate rests.
  • Page 26 • Attach the heat shield to grease tray with #8x3/8” sheet metal screws (A). • Place grease pan into grease tray, then place the tray into the cart (B). Heat Shield #8x3/8" Grease Tray Sheet Metal Screws Qty. 4 CAUTION Failure to install grease tray and grease pan will cause hot grease to drip from bottom of grill with risk of...

  • Page 27: Troubleshooting

    EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from • Damaged hose. • Turn off gas at LP cylinder or at source on natural gas systems. If cracked/cut/burned anything but burned, replace valve/hose/regulator.
  • Page 28 Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light ELECTRONIC IGNITION: using ignitor. • No spark, no ignition noise. • See Section I of Electronic Ignition System. (See Electronic Ignition Troubleshooting also) • No spark, some ignition noise. • See Section II of Electronic Ignition System. •...
  • Page 29 Troubleshooting - Electronic Ignition Problem (Ignition) Possible Cause Check Procedure Prevention/Solution SECTION I No sparks appear at • Battery not installed • Check battery orientation. • Install battery (make sure that “+” and “–” any electrodes when properly. connectors are oriented correctly, with “+” end up Electronic Ignition Button and “–”...
  • Page 30 NOTES...

  • Page 31: Registration Card

    Warranty Registration Department P.O. Box 1240 Columbus, GA 31902-1240...

Table of Contents