Toshiba SD-V383SC Owner's Manual page 14

Connections (Continued)
Connecting to an amplifier equipped with two channel
digital stereo (PCM) or to an Audio/Video receiver
equipped with a multi-channel decoder (Dolby
Digital™, MPEG 2, or DTS)
1. Connect one of the DVD+VCR's DIGITAL AUDIO
OUT jacks (COAXIAL X) to the corresponding in
jack on your amplifier. Use an optional digital
(COAXIAL X) audio cable.
2. You will need to activate the DVD+VCR's digital out-
put. (See "AUDIO" on page 19).
Digital Multi-channel sound
A digital multi-channel connection provides the best
sound quality. For this you need a multi-channel
Audio/Video receiver that supports one or more of the
audio formats supported by your DVD+VCR (MPEG 2,
Dolby Digital and DTS). Check the receiver manual and
the logos on the front of the receiver.
Caution:
Due to the DTS Licensing agreement, the digital
output will be in DTS digital out when DTS audio stream
is selected.
Notes:
• If the audio format of the digital output does not match the
capabilities of your receiver, the receiver will produce a strong,
distorted sound or no sound at all.
• Six Channel Digital Surround Sound via digital connection
can only be obtained if your receiver is equipped with a
Digital Multi-channel decoder.
• To see the audio format of the current DVD in the on-
screen display, press AUDIO.
Rear of DVD+VCR
A1 A2
R
L
AUDIO INPUT
Amplifier (Receiver)
14
Accessory Audio/Video (A/V) Connections to
DVD+VCR
Connect the VCR IN LINE 1 or LINE IN 2 jacks on the
DVD+VCR to the audio/video out jacks on your acces-
sory component, using the optional audio/video cables.
(Refer to page 26 for "Recording from External
Components")
X
COAXIAL
DIGITAL INPUT